INT 1A U - Disk Spool II v2.07+ - FUNCTION CALLS AH = D0h AL = function code 01h enable spooler and despooler 02h enable spooler only 03h enable despooler at beginning of file 04h disable the despooler 05h disable the despooler and spooler 06h clear the spool file 08h inhibit the popup menu 09h enable the popup menu 0Ah ??? (called by Disk Spool's INT 21 handler) 0Bh disable the spooler 0Ch start despooler after last successfully printed document 0Dh start despooler at the exact point where it last left off 0Eh pop up the menu 0Fh ??? 11h start new spool file??? (called by Disk Spool's INT 21 handler when a program terminates) 14h ??? 15h delete despool file and reset ??? 16h ??? (writes something to unknown file) 17h ??? (writes something to despool file, then reads something else and ???) 18h ??? (reads something from despool file, and then ???) 19h ??? (creates/truncates spool file) 20h clear file pointed to by the despooler 21h ??? (writes something to unknown file) 22h ??? (writes something to spool file if spooler/despooler using same file) 23h ??? (opens/creates unknown file, then ???) 30h ??? 31h ??? 32h beep 33h append CRLF to spool file??? 34h ??? 35h ??? 36h ??? 37h append CRLF to spool file and start a new spool file??? 38h ??? 40h ??? (v4.05) 41h ??? (v4.05) 51h ??? (called by Disk Spool's INT 21 handler) 52h ??? (called by Disk Spool's INT 21 handler) 57h ??? 5Ah ??? (v4.05) 5Bh ??? (v4.05) 5Ch ??? (v4.05) Note: this function is also supported by Vertisoft's Emulaser utility ELSPL, as that is a licensed version of Disk Spool II SeeAlso: AH=A0h,AH=ADh