INT 7A - Novell NetWare - SPX Driver - GET SPX CONNECTION STATUS BX = 0015h DX = connection ID ES:SI -> status buffer (see #03828) Return: AL = return code (00h,EEh) (see also #03825) 00h connection still valid ES:SI -> status buffer filled Note: this function is supported by Advanced NetWare 2.1+ SeeAlso: BX=0010h,BX=0011h Format of SPX status buffer: Offset Size Description (Table 03828) 00h BYTE connection state 01h waiting to establish connection 02h starting (attempting to create connection) 03h connection established 04h terminating 01h BYTE watchdog flag bit 0: used internally by SPX bit 1: SPX watchdog is monitoring connection bits 2-7 used internally by SPX 02h WORD (big-endian) source connection ID 04h WORD (big-endian) destination connection ID 06h WORD (big-endian) sequence number of next packet sent 08h WORD (big-endian) acknowledge number, expected sequence number of next received packet 0Ah WORD (big-endian) maximum sequence number remote SPX may send without ACK from local SPX 0Ch WORD (big-endian) remote acknowledge number, next sequence number remote SPX expects to receive 0Eh WORD (big-endian) remote allocation number, maximum sequence number local SPX may send 10h WORD (big-endian) connection socket 12h 6 BYTEs immediate node address--bridge on local network to destination 18h 10 BYTEs destination internetwork address (see #03824 at INT 7A/BX=000Bh) 22h WORD (big-endian) retransmit count 24h WORD (big-endian) estimated roundtrip delay 26h WORD (big-endian) retransmitted packets 28h WORD (big-endian) suppressed packets 2Ah 12 BYTEs ??? (v2.15)